DROWsports CS-1 GY6 Stainless Steel Exhaust System - GY6 7" Fatty

$599.00
CS-1 GY6 Stainless Steel Exhaust System for 7" Fatty Rear Wheel

Over the years we at DROWsports has been developing and testing GY6 exhaust system for our big bore motors and Ruckus Swap Kits.  With each exhaust system we fabricated, we added small improvements to meet our needs like using a Stainless Steel 1/4" laser cut exhaust header flange to improve exhaust gasket seal or adding an oxygen sensor bung for wideband carburetor tuning.   We also notice that a one size fit all (non-fatty vs. fatty) GY6 exhaust system has ground clearance issue on lowered bikes, so we design our exhaust piping to sit right up against the motor for maximum ground clearance.  DROWsports GY6 Exhaust system is designed to work with any size displacement from a125cc to 232cc built motor.

NOTE: This Exhaust was design to work with our DROWsports GY6 150cc Rear Hugger Fender.

DROWsports CS-1 GY6 Stainless Steel Exhaust System 7 Inch Fatty

  • GY6 125cc to 232cc Engine
  • 1.25" Header to 1.50"
  • 100% Tig Welded
  • 1/4" Exhaust Header Flange
  • Stainless Steel Mounting Bracket
  • Oxygen Sensor Bung for Wideband Tuning
  • Full Stainless Steel Constrution 
  • Hand Made in the USA
More Information
SKUDROW-EXH-GY6-7
BrandDROWsports
VehicleGY6 150cc
Write Your Own Review
You're reviewing:DROWsports CS-1 GY6 Stainless Steel Exhaust System - GY6 7" Fatty