Frando FMF-130S Forged Radial Master Cylinder (Left)
Frando FMF-130S Forged Radial Master Cylinder (Left)
Frando FMF-130S Forged Radial Master Cylinder (Left)

Frando

Frando FMF-130S Forged Radial Master Cylinder (Left)

Sale price$279.00
Quantity:
Pickup available at 1860 Obispo Avenue Usually ready in 2-4 days

Frando FMF-130S Forged Radial Master Cylinder (Left)

1860 Obispo Avenue

Pickup available, usually ready in 2-4 days

1860 Obispo Avenue
C
Signal Hill CA 90755
United States

+15624944990

The Frando FMF-130S puts a forged radial master cylinder on the left bar. That's the direct-push setup you'd normally only see on the right side. It's built for mini bikes and scooters that run a hand-operated brake on the left lever.

With a radial master cylinder the lever pushes straight into the piston instead of turning a 90° corner like an axial unit. You lose less force to friction, the bite point is clearer, and you get finer feedback through your fingers. The 14mm piston gives a firm, controlled lever. It's a good match for single-caliper setups and 2-piston calipers like the Frando FCC-660.

The body and lever are both forged 6061-T6 aluminum, so it's stiff where it counts. The lever pivot runs on bearings and stays smooth. You can adjust the lever ratio between 17mm and 20mm to dial in initial bite against progression. A separate knob adjusts lever reach, and the lever folds outward in a tip-over instead of snapping.

It comes with a smoked reservoir and clamp, a body-mounted electronic brake light switch, a single M10 x 1.25 banjo bolt, and a mirror mount.

Highlights:

  • Radial (direct-push) design gives a sharper bite point and better modulation
  • Left-hand version with a 14mm piston
  • Forged 6061-T6 aluminum body and lever
  • Bearing-supported lever pivot
  • Lever ratio adjusts from 17mm to 20mm [CONFIRM]
  • Lever reach adjuster
  • Folding lever helps it survive a tip-over
  • Electronic brake light switch mounted on the body
  • Smoked reservoir, single banjo bolt, and mirror mount included

Specifications:

Spec Detail
Brand Frando
Model FMF-130S
Part Number / SKU FMF-130S-14LLB
Side Left hand
Type Forged radial (direct-push) brake master cylinder
Piston Diameter 14mm (9/16")
Body Material Forged 6061-T6 aluminum
Lever Material Forged 6061-T6 aluminum
Piston Material Hard-anodized aluminum
Lever Ratio Adjustment 17–20mm [CONFIRM: Frando's own spec page says 18–20mm]
Lever Length  Long
Handlebar Diameter 22.2mm (7/8") bars or clip-ons
Banjo Thread M10 x 1.25
Brake Fluid DOT 4 or DOT 5.1 only
Brake Light Switch Electronic switch mounted on the body (included)
Color  Black Edition

Fitment: Universal. It fits 22.2mm (7/8") handlebars or clip-ons and is meant for a hand-operated brake on the left side, which is the rear brake on most scooters. Before you order, make sure the 14mm bore suits your caliper's piston area.